HAZARD ZONE - MAINTENANCE UNITS
MAINTENANCE UNIT SAFETY
Compressors, pumps, generators and other maintenance units brought onto site for a repair or upgrade bring their own tangle of temporary cables, hoses and tools – right in the middle of a working area that was not built around them.
THE SITUATION ON SITE
Portable maintenance units – generators, compressors, pumps, welding sets and similar equipment – are typically parked as close as possible to the job, which usually means directly in or beside an active walkway, work area or vehicle route.
Every one of these units needs power, air or fluid lines running to and from it, and those lines cross ground that other people are walking, working and driving over for as long as the unit is on site – sometimes for the length of an entire maintenance job.
CableSafe supplies cable and hose management equipment built to protect these temporary lines from vehicle and foot traffic while keeping the working area around the unit clear and organized.
COMMON HAZARDS
Trip hazards from power, air and fluid lines
Cables and hoses running from the unit to the work point cross walkways and work areas, creating a trip hazard for everyone passing through.
Vehicle crush and snag risk
Lines that cross a vehicle route without protection can be crushed, snagged or dragged by forklifts, trucks and other site vehicles, damaging equipment and creating further hazards.
Cluttered work area around the unit
Without organized cable and hose management, the area immediately around a maintenance unit becomes cluttered, slowing down the crew and increasing the risk of a slip or trip right where people are working.
CABLESAFE SOLUTIONS
Sicherheit am Kabel
Cable guards, ramps and stands protect power, air and fluid lines running from the unit, wherever they cross a walkway or vehicle route.
Verhinderung fallengelassener Gegenstände
Safety hooks keep tools, fittings and hose ends organized and off the ground around the unit while the crew works.
BUILT FOR EQUIPMENT THAT MOVES BETWEEN JOBS
A maintenance unit rarely stays in one spot for long – it moves from job to job, sometimes daily. CableSafe cable guards and ramps are designed for fast, repeated set-up and take-down, so the lines running to and from the unit are protected everywhere it goes.
Heavy-duty cable guards handle vehicle crossings near the unit’s working area, while lighter guards and ramps cover pedestrian walkways – both without a permanent site installation.
WHY MAINTENANCE CREWS SPECIFY CABLESAFE
Westmark B.V., trading as CableSafe, has supplied industrial safety hardware since 1991. Our cable guards and safety hooks are built for equipment that moves from job to job, set up and taken down repeatedly.
Our products are manufactured to relevant EN 1263-1 standards and international dropped-objects prevention (DROPS) guidance, giving maintenance teams a specified, documented solution rather than an improvised fix.
CableSafe equipment is used by maintenance crews across construction, oil and gas, petrochemical, mining and manufacturing sites in Europe and the US, wherever portable units need safe, temporary cable and hose management.
40+ YRS
supplying industrial safety hardware
3 AREAS
cable, dropped objects & confined space
EU + USA
standards-aligned product range
1 DAY
typical dispatch from stock
FREQUENTLY ASKED QUESTIONS
PROTECT THE LINES, WHEREVER THE UNIT GOES
From cable guards to safety hooks, CableSafe equips portable maintenance units for safe, repeatable set-up wherever the job takes them. Talk to our team about your next maintenance job.