HAZARD ZONE - CLASSIFIED / HAZARDOUS AREAS
HAZARDOUS AREA SAFETY
Classified or hazardous areas – zones where flammable gases, vapours or combustible dust may be present – demand extra discipline around cables, hoses and portable equipment on the floor. A loose cable or an unsecured tool is a bigger risk here than almost anywhere else on site.
THE SITUATION ON SITE
Classified or hazardous areas – around process units, tank farms, well pads and other zones where flammable atmospheres may occur – carry every ordinary housekeeping risk plus a much higher consequence if that risk turns into an ignition source or an emergency-response obstruction.
Temporary cables, hoses and portable equipment brought in for maintenance or turnaround work still have to cross these zones. Left loose on the ground, they become trip hazards in an area where a fall or a dropped tool carries added risk, and where emergency egress routes must stay completely clear.
CableSafe supplies cable management and dropped-objects equipment built for these conditions – keeping temporary cable runs and portable gear organized and off the floor without adding a fixed installation to a zone that is inspected and controlled.
COMMON HAZARDS
Trip hazards from loose cable and hose runs
Temporary power, air and communication lines crossing a hazardous area walkway are a trip hazard that also risks damaging the cable itself if left underfoot.
Blocked emergency egress routes
Cables, hoses and portable gear left across a designated escape route can slow or block evacuation in an emergency, when every second matters.
Dropped tools and equipment
Portable tools and equipment used during maintenance in a hazardous area need to be secured – a dropped tool is a hazard on its own and can also damage nearby equipment.
CABLESAFE SOLUTIONS
Sicherheit am Kabel
Cable ramps, guards and stands lift temporary cables and hoses off walkways and out of emergency egress routes, keeping the zone clear without a permanent installation.
Verhinderung fallengelassener Gegenstände
Tool tethers and catch nets secure portable equipment used during maintenance work inside classified areas, reducing dropped-object risk at height and at grade.
KEEPING EGRESS ROUTES CLEAR
In a classified area, a clear emergency egress route is not just good housekeeping – it is often a specific, auditable requirement. Temporary cable and hose runs that cross a designated route need to be raised, guarded or routed around it, not just left flat on the ground.
CableSafe cable ramps and guards are designed for quick installation and removal by the maintenance crew itself, so egress routes stay clear throughout a turnaround or outage, not just at the start and end.
WHY TURNAROUND TEAMS SPECIFY CABLESAFE
Westmark B.V., trading as CableSafe, has supplied industrial safety hardware since 1991. Our cable and dropped-objects equipment is built for the pace of a shutdown or turnaround, where hundreds of temporary cable runs go in and out over a matter of days.
Our products are manufactured to relevant EN 1263-1 and international dropped-objects prevention (DROPS) guidance, giving HSE and turnaround planning teams a specified, documented solution rather than an improvised one.
CableSafe equipment is used across oil and gas, petrochemical and refinery turnarounds, mining and manufacturing outages in Europe and the US, wherever temporary cable and equipment management in a classified area matters.
40+ YRS
supplying industrial safety hardware
3 AREAS
cable, dropped objects & confined space
EU + USA
standards-aligned product range
1 DAY
typical dispatch from stock
FREQUENTLY ASKED QUESTIONS
KEEP THE ZONE CLEAR, KEEP THE EXIT OPEN
From cable ramps to tool tethers, CableSafe equips classified and hazardous areas for safe temporary cable and equipment management. Talk to our team about your next turnaround or outage.